Filter
Top Products
24
The CameraConnect Pro will not install. (No Drive Letter Assigned)
You may not have enough drive letters available to your system. In Windows 95 or
Windows 98, right-click the My Computer icon on the desktop and choose Proper-
ties from the menu that appears. In the System Properties window, click on the
Device Manager tab. Double-click the Disk Drives icon in the device tree to show
what drives are installed in the system. Click once on Parallel Flash Drive to select it,
then click Properties to display the Properties Window. Now click the Settings tab to
access the drive letter information. The information below should be displayed.
At the bottom of the window there will be an option selection box for Reserved drive
letters. Click once on the Start drive letter box as shown in the picture. The start
drive letter must be greater than the total number of disk drives and CD-ROM
drives in your system. After you have set the start drive letter, set the End drive letter
to Z. Restart your system and check My Computer. Your CameraConnect Pro should
be listed as a Removable Drive.
Note: Never select “Int 13 unit”. Your system will stop responding.
You may need to do a “clean” installation of the CameraConnect Pro software in your
system. See Appendix A for instructions on how to uninstall the software. When the
softwaere has been uninstalled, remove the parallel port from the Device Manager
listing (it can be found under the heading “Ports.”) Shut down, rather than restart,
your computer, then turn it back on again and reinstall the software.