Toshiba pmn Digital Camera User Manual


 
105104
Symptom Cause Remedy
Function
Play-
back
Images cannot
be replayed by
the PC.
Contact the manufacturer
of the PC or the software.
Opera-
tion
The camera can't
be connected to
the PC using
USB cable.
Battery power is
depleted.
Use the AC adapter
instead.
The power of the
camera isn't on.
Turn the power on.
USB cable isn't
connected properly.
Pull out the cable once
from the camera, then
connect it again. Make
sure [PC MODE] is
displayed on the LCD
monitor of the camera (see
page 95).
Other USB ports on
the PC have been
connected to other
devices.
Disconnect devices other
than the keyboard and
mouse from the ports, and
try again.
Symptom Cause Remedy
Function
Erasing
Image cannot be
erased
Image data was
recorded on a different
camera or device.
The image cannot be erased
normally by the camera. The
card can be reformatted to
erase all images.
The number of
images recordable
didnt change
when an image
was erased.
The size of the erased
image file was very
small.
File size and number of
pictures recordable differ
depending on the image
quality mode and subject
conditions; not a malfunction.
Recharg-
ing
Cant recharge
the camera.
No lithium ion battery
pack is loaded.
Insert the battery pack into
the camera.
Cant recharge
the camera. Or it
is canceled
midway through.
Caution LED
flashes slowly.
Ambient temperature is
too high or too low,
causing the chargers
protect circuits to
operate and interrupt
the recharging function.
Ambient temperature during
recharging should be
between +10°C and +30°C.
(In practice, a range of +5°C
- +40°C is possible, but the
recharging time may
become somewhat longer).
Nothing appears
on the LCD
monitor.
Battery power is
depleted, or no battery
pack is loaded.
Insert the lithium ion battery
pack into the camera and
recharge if necessary.
Nothing appears
on the LCD
monitor.
The auto-off function
has operated to turn
power off (page 78).
Image cannot be
erased;
mark appears.
The image is protected. Release the image protect
function (page 63).
Image cannot be
rotated or set for
DPOF.
The write protect
switch is set (SD
memory card).
Release the SD memory
cards write protect lock
(page 25).
Play-
back
Other
Press the main power
switch again to turn power
ON.
The camera feels
hot.
Large power consumption
occurs during use of the
LCD monitor; the camera
may feel warm when the
LCD monitor is used for a
long period of time.
This in itself is not a
malfunction, but the
camera should be allowed
to cool before continuing
use.
Other
Nothing appears
on the LCD
monitor.
Battery power is
depleted, or no battery
pack is loaded.
Replace the battery pack
with the charged one.
The battery runs
out too soon.
The camera is used
under extremely low
temperature.
Warm the battery in your
pocket and attach it just
when you want to operate
the camera.
The terminal is dirty. Wipe out the battery
terminal with a dry, clean
cloth.
Battery life is over. Replace the battery pack
with a new one.
The USB driver has
not been installed yet.
Install the USB driver (see
pages 92 and 93).