Toshiba pmn Digital Camera User Manual


 
111110
For customers in the U.S.A.
FCC Statement
This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
NOTE
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation.
This equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to
correct the interference by one or
more of the following measures:
Change the direction of the radio or
TV antenna.
Move the equipment or the radio or
TV. For example, if the equipment is
to the right of the TV, move it to the
left of the TV.
Or, move the equipment farther
away from the radio or TV.
Plug the equipment into a different
outlet. DonÅft plug your radio or TV
into the same circuit as your
equipment.
Ensure that all expansion slots (on
the back or side of the equipment)
are covered.
Also, ensure that all metal retaining
brackets are tightly attached to the
equipment.
If these suggestions donÅft help,
consult your equipment dealer or
experienced radio/TV technician for
help.
CAUTION
If you modify the camera in any way,
without getting approval from Toshiba
Corporation, your camera may violate
FCC regulations. Violation of FCC
regulations may cause the FCC to void
your right to use the modified camera.
For customers in Canada
CAUTION
This Class B digital apparatus
complies with Canadian ICES-003.
Cet appareil numérique de la classe B
est conforme à la norme NMB-003 du
Canada.
Self-timer LED (red): lights to indicate self-timer operation, recording
completed
, or connected to a PC
.
Card access LED (orange): lights while recording the image, processing the alart,
writing to the memory card.
Standby LED (green): lights to indicate focus display, or finished recharging
the lithium ion battery pack.
Caution LED (red): lights to indicate flash charging, camera-shake warning,
lithium ion battery pack recharging and malfunction.
<Input/Output>
Video output mode: NTSC/PAL composite video signal selectable
Input/output connector: video output connector (3.5 mm minijack); external
power input connector; DIGITAL Input/Output connector
(the exclusive square 8-pin connector).
<Battery/Power>
Power: 3.6V lithium ion battery pack, dedicated AC adapter
Recharging time: about 5 hours (for fully recharging the battery at +10°C -
+30°C)
Battery capacity: Number of images recordable: (using 50% flash, Fine
Mode):
LCD monitor ON: about 100
LCD monitor OFF: about 150
Continuous playback time: about 50 minutes (using
LCD monitor)
(All values assume full battery charge, room
temperature, based on our testing standards).
<Other>
Ambient operating temperature: 0°C - 45°C
Dimensions: 91(W)×57(H)×31.5(D) mm (not including protruding
parts)
Weight: About 175 g (not including memory card or battery
pack)
* All descriptions and specifications are subject to change without notice.