Filter
Top Products
12
Knock out
1212
Hardware Installation
First, use the supplied driver to detach the dome cover from the camera base.
Then, follow the steps below to install the camera; either to a ceiling or to a wall.
Notes:
l
The attached screws and anchors are used to install the
camera to a solid surface. (e.g. concrete) If installing on loose
or thin material surfaces , use the appropriate anchors (not
included) with the screws.
l
Install the camera tightly.
Mounting the camera to a solid surface
(1) Attach the Alignment Sticker to the surface.
(2) Drill two pilot holes (Ø0.28inch×1.57inches(D)
(Ø7mm×40mm(D))) through the two circles on the sticker.
(3) Hammer the supplied plastic anchors into the holes.
(4) Drill a hole (Ø1.25inch(Ø30mm)) in the center of the sticker,
and lead the cables in this hole.
(5) Align the two holes of the Camera with the two plastic
anchors; insert the supplied two screws to corresponding holes
and secure them with a driver.
Cable installation
All cables are turned along the back side of camera,
and leaded to the hole of ceiling or wall.
When you do not lead the cable to the backside hole of
camera, cut out the knock out of the cover.
NOTE
l
Installation should be done only by qualied personnel and conform to all local codes.
l
Install this camera on a rm and solid part of the ceiling or wall.
If installed on a weak place the camera could fall causing injury and damage.
Notice of installation near a wall
A screw driver is required to tighten the dome cover. Ensure that the camera is installed
with sufcient clearance for tightening the dome cover.
Alignment sticker
Alignment sticker