Filter
Top Products
12
Applying Power Using Standard AC Power
To power the scanner from an AC outlet, use the provided AC adapter with a 5.5 mm outer
diameter/2.1mm inner diameter tip.
Caution: You must use a Class 2 power source that supplies 12V DC and delivers at
least 500 mA. The cord connector’s center tip must be set to positive
and its plug must t the scanner’s DC 12V jack. Using an adapter that does not
meet these specications could damage the scanner or the adapter.
• Always connect the AC adapter to the scanner before you connect it to AC power.
When you nish, disconnect the adapter from the AC power before you disconnect it
from the scanner.
1. Insert the adapter’s barrel plug into the
DC 12V jack on the rear of the scanner.
2. Plug the adapter into a standard AC outlet.
Use only the AC adapter supplied with
your scanner.
Connecting an External Speaker
In a noisy area, an external speaker (available at a local electronics store) positioned in the
right place might provide more comfortable listening.
Plug the speaker cable’s 1/8 inch (3.5 mm)
plug into your scanner’s EXT. SP jack.
Note: Connecting an external speaker
disconnects the scanner’s
internal speaker.
Listening Safely
• Do not use the earphone. The volume is not adjustable for the Warning Alert and
damage to your hearing could occur.
Connecting the Clone Cable
You can transfer the programmed data to and from another UBCT9 scanner using
a RS232C Straight Cable (9 pin to 9 pin) (not supplied). Connect the cable between
each scanner’s REMOTE jacks. See “Clone Mode” on page 49. You can also upload
or download the programmed data to or from a PC using the UBCT9-SS programming
software included with the UBCT9.
UBCT9 OM 12 12/11/07 3:52:55 PM