Filter
Top Products
18
When the scanner is staying on a frequency, “- - - - - -“
will be displayed during “C-C” term instead of the
frequency.
Close Call Operation
1. When a signal is detected, the scanner alerts
(depending on the Set Close Call Alert setting, page
20) and immediately jumps to the Close Call
frequency. But, the frequency is not displayed.
NOTE: Close Call does not work during selecting the
band search, selecting the State code and
programming mode.
If you want to conrm the frequency, press
any key.
Even if a signal is lost, the scanner stops at this
frequency for 10 seconds (if delay is on). After
10 seconds, the scanner resumes previous
scanning.
2. If you press HOLD during the transmission or
the delay time, the Scanner enters Close Call
Hold mode and stays on the frequency.
During the hold mode, the scanner does not
check any other signal.
3. Press HOLD to resume the signal searching.
4 a. If you press HOLD while the scanner is
searching the signal, the scanner stops the
and displays the current search Band.
b. Press or to select the searching band.
c. If you press L/O, you can set search skip
frequency.
d. To clear all the skip frequencies, hold L/O
for over 2 seconds.
UBCT9 OM 18 12/11/07 3:53:36 PM