LEDs, Switches, and Jumpers
Debug LED Switch (SW3) Settings
The Debug LED switch (SW3) is a four-position switch used for system maintenance. S1 and
S2 function as a pair. The default positions on this switch are Off and Reserved, and they are
not modified by the user. Table 5-6 shows the configurations of SW3.
Table 5-6: Debug LED Switch (SW3) Settings
Position Function Setting Description
S1/S2 Debug LED switch Off/Off Port 84
Off/On SmartArray 5i diagnostic LEDs
On/Off iLO diagnostic LEDs
On/On Port 84
S3 Reserved Off Reserved
S4 Reserved Off Reserved
Clearing and Resetting System Password Settings
It may be necessary to clear and reset the system password.
IMPORTANT: This method of clearing and resetting system passwords is necessary only if
the current password is not known.
Otherwise, when prompted, the password can be entered followed by a forward slash (/). This
operation removes the current password and allows one of the following to be performed:
• Enter the RBSU and set the password to a new value.
• Leave the password value blank to disable the password feature.
When the system switch position S5 is set to the On position, the system is prepared to clear
the system password.
1. Power down the server.
2. Set the switch at position 5 to the On position.
3. Restart the server, and wait for confirmation.
4. Power down the server.
5. Set the switch at position 5 to the default Off position.
6. Restart the server. The password is cleared.
HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide 5-7
