109
6
Correcting the amount of light produced
by the flash—Flash intensity control
You can adjust the amount of light emitted by the flash to correspond with
your shooting requirements.
1
Press to display Menu.
2
Press on the Arrow pad to
select , then press .
3
Press to increase/decrease
the amount of light emitted.
● appears on the control panel.
● Use to increase/decrease the
value.
: The exposure is corrected by a
+1/3 EV step with each press.
: The exposure is corrected by a
–1/3 EV step with eachpress.
● Correction can be made within a
range of ±2EV (ExposureValue).
4
Press the OK button.
● The setting is stored in memory
and the Menu disappears.
2, 3
4
1
[
2/5
]
F2.8 1/800 0.0
P
BKT
MULTI
METERING
SLOW
0
[
SM
]
Control panel
Flash intensity control
● If the FL-40 extension flash is set to TTL-AUTO and used simultaneously
with the main flash, correction is made for the amount of light emitted by
both flashes.
● If the FL-40 external flash is set to MANUAL and used simultaneously with
the main flash, correction is made only for the amount of light emitted by the
main flash only.
● The flash correction effect may not be sufficient if the shutter speed is too fast.
Note:
