Filter
Top Products
23
y The flash charging time may increase when the battery is low.
y The screen is blank when the flash is charging. The next image can be shot only
when charging is completed.
y Shooting with a flash in a bright environment may cause incorrect exposure.
Using the Selftimer
Use the selftimer to set a delay from the time the shutter button is pressed to the time
the image is shot. Use Burst to record continuous still image shooting.
Turn the power on, and set the camera to the Capture mode (
page 13).
Open the REC menu ( page 15).
Change the setting.
Press Mode button to launch the submenu. Press
or to select [Seftimer],
then press OK/Enter to confirm the setting.
Disable: Do not use Selftimer.
10 sec.:
The shutter release will delay for 10 seconds.
20 sec.
The shutter release will delay for 20 seconds.
Press the MENU button to close the menu list. Press the shutter button to
take a picture.
y When using the selftimer function, be sure to use a tripod or place the digital
camera on a level, stable surface.
y When using the selftimer function the selftimer lamp will blink and turn off after
the picture is taken.
C
C
a
a
u
u
t
t
i
i
o
o
n
n
4
T
T
i
i
p
p
s
s
1
2
3