Filter
Top Products
128-6951
11 of 12
Surface Mount Installation:
1. Locate suitable mounting location in the rear center of the vehicle and
use the support bracket (# 2) as a template to mark and drill two 5/32”
holes on the mounting location.
2. Put the support bracket (# 2) onto the camera neck, then screw the lock
nut along the camera neck to secure the bracket (# 2) to the camera
body (# 1) in the showed direction.
3. Screw the combine screws (or tapping screws) into the holes to attach
the camera support bracket to the vehicle with the camera cable facing
downwards.
4. Place the protective cover (# 4) on the support bracket, then place the
flat washer 1 (# 6) and top cover (# 5) on the camera neck. Tighten the
top cover (# 5) to the further location along the camera neck towards
the camera body.
5. Route the camera cable thru an existing grommet into the vehicle.
6. Connect the camera cable to the extension cable and route towards the
monitor.
10