Filter
Top Products
We recommend mounting the antenna on a roof as high
up as possible as shown on page 4. The antenna should
not be blocked by an obstruction like trees or a chimney.
Once you have determined your mounting location, place
the mounting bracket on that location on the roof. Take
your drill and pre-drill holes, using a 3/32 drill bit, through
the top two holes on the mounting bracket. Screw in two
of the #10 screws included with this package, through the
mounting bracket into the pre-drilled holes in the roof.
Repeat this step for the bottom two holes. At this point,
move onto the Adjustment section of the owner’s manual
on page 6.
Mast Mount
The XM6 can be mounted to most masts. We recommend
mounting the antenna to a mast on the roof or on the mast
of a satellite TV dish. You will need the 2 U-bolts, 2 mount
brackets and 4 nuts for this installation. Once you have
determined where on the mast you wish to mount the
antenna, place the mounting bracket in that location against
the mast. Put one of the U-bolts through the top two holes
on the mounting bracket. Take one of the mount brackets
and insert it through the two ends of the U-bolt on the other
side of the mast. Make sure the inside of the curve of the
mount bracket is towards the mast. Using one hand to hold
the mounting bracket and U-bolt bracket take your other
hand and place one nut on one end of the U-bolt, then turn
the nut four or five complete rotations and then place one
nut on the other end of the U-bolt, turn the nut four or five
complete rotations. Make sure the mounting bracket is in
the desired location and tighten both nuts until the mounting
br
acket is secure on the mast. Before mounting the bottom
U-bolt, pl
ease r
ef
er t
o the last step on the Cable Installation
section on page 6. Repeat these steps for the second U-bolt.
Once complete, move to the Adjustment section of the
owner’s manual on page 6.
There are two areas of adjustments on the antenna, the To
Now that you have determined where to place the antenna,
you have three different mounting options. Each option is
described below.
Wall Mount
Please determine where to mount the antenna. Once
the mounting location has been determined, take a
pencil and mark through the bracket, onto the house
wall, the four screw locations. Then set the mounting
bracket down and pre-drill holes in the four locations
you just marked (drill bit size 3/32 is recommended with
#10 screws). Position the mounting bracket over the four
pre-drilled holes and screw in the top two #10 screws,
that are included with this package through the mounting
bracket into the wall of the house. Then screw in the
bottom two. At this point, move onto the Adjustment
section of the owner‘s manual on page 6.
Roof Mount
Installation
XM6
5
Installation
XM6
4
or