Filter
Top Products
Page 4 AXIS 262 Installation Guide
Overview - rear panel
RS-232 connector - For the connection of a UPS (Uninterrptible Power Supply) unit. For
approved models, see the AXIS 262 User’s Manual.
Network connector - Connect the AXIS 262 to your network using a standard CAT-5 network
cable.
I/O terminal connector - Used to connect external devices. See the AXIS 262 User’s Manual
for more information.
Factory setup button - Used to reset the unit to the factory default settings. See page 8.
Power button - To shut the unit down correctly, press and hold this button until a “beep”
sound is heard. Shutdown will then complete after approximately 20 seconds. To start the unit,
press the button once.
Power adapter connector - Attach the supplied power adapter here.
Power
connector
9-pin I/O terminal
connector
Network
connector
Rear panel
Serial number
Power button
RS-232
connector
Factory setup button
adapter