Filter
Top Products
Bubble Replacement Instructions
1. Loosen the two M3x23L screws (3) from the bubble on the camera.
2. Detach the Bubble Assembly (2) from the camera.
3. Remove the screw that secures the Safety Tether to the Bubble. Keep the screw to secure
the bubble replacement.
4. Attach the Safety Tether from the camera housing to the replacement bubble using the
screw removed above.
5. Attach the replacement bubble to the camera housing.
6. Secure the replacement bubble to the camera housing with the two M3x23L Torx screws
(preinstalled in the Bubble Assembly).
AUTODOME 5000 PTZ Camera Replacing the Bubble | en 19
Bosch Security Systems, Inc. Installation Guide 2013.07 | 1.3 |