Filter
Top Products
Solution 64
24
Bosch Security Systems 09/06 BLCC110U
User Guide
Devices > Keypads >
Backlight
MENU 6-1-2
This menu allows you to adjust the brightness of the keypad’s
LCD display backlight. Each keypad can have their display
adjusted separately.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [6] + [1] + [2].
The keypad will display the backlight screen.
L
Keypad 001 Backlight
Press
SAVE
OK
to
H
Use the [←] and [→] keys to adjust the bar until the
desired backlight is reached.
Press [OK] to save and exit, or press [MENU] to exit
without saving.
System Events
Options in this section relate to programming of system wide
options and interpretation of system trouble events when and
if they occur. Some events such as open zones will appear and
single events while other may be grouped together. In this case
you need to drill down to see the specific detail for each event.
Your installer will advise you how to interrogate system trouble
events.
System > Commands >
Panel Status
MENU 7-0-0
The panel staus menu displays the panel software version
information as well as highlighting any system troubles that
are currently in effect. This is a view only location.
System > Commands >
System Trouble
MENU 7-0-1
The System Trouble Menu displays all current system troubles
in a list format. Some trouble events require you to drill down
and non-system trouble that are curent within the Solution 64
control panel.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [7] + [0] + [1].
The keypad will display a list of all current system and
non system trouble conditions.
To determine the system trouble condition, highlight the
panel number (P001 to P002) that you want to view using
the [↑] and [↓] keys, then press [OK] to select.
P001 System Trouble
Z001 Zone 1 Name
Z002 Zone 2 Name
Press OK or MENU
2.
3.
To determine the non system (zone) trouble condition,
highlight the zone number Z001 to Z064) that you want
to view using the [
↑] and [↓] keys, then press [OK] to
select.
P001 System Trouble
Z001 Zone 1 Name
Z002 Zone 2 Name
Press OK or MENU
2. If viewing system trouble conditions, the keypad will
display similar to the following:
Panel 001 P001
Voltage= 13.9V Temp=36
Date And Time
Press OK or MENU
The third line of the keypad display scrolls between all
current system trouble events.
If viewing non-system trouble conditions, the keypad will
display similar to the following:
Zone 1 Name Z001
EOL = Open
Press OK or MENU
3. Press [OK] or [MENU] to exit the system trouble menu
command:
If there are no system troubles, the keypad will display:
There are no
System troubles.
Press OK or MENU
Refer to the Trouble Messages table for a complete list of
trouble events and their meanings.