Filter
Top Products
140 en | Troubleshooting IP Camera 200 Series
AR18-10-B012 | v1.54 | 2011.08 Installation and Operation Manual Bosch Security Systems
8 Troubleshooting
8.1 LED indicators
The camera has LEDs on the front and the rear panel that show
the operating status and can indicate possible malfunctions.
Power LED
Does not light up: Camera is switched off.
Lights red: Startup in progress.
Lights green: Camera is switched on.
Flashes green: Video connection established.
Flashes red: Camera is faulty, for example, following failed
firmware upload.
8.2 Resolving problems
The following table is intended to help identify the causes of
malfunctions and correct them when possible.
8.3 Customer service
If a fault cannot be resolved, please contact your supplier or
system integrator, or contact Bosch Security Systems
Customer Service directly.
The Installer should write down all information regarding the
unit so that it can be referenced for warranty or repair. The
Malfunction Possible causes Solution
No image
transmission to
remote location.
Faulty cable connections. Check all cables, plugs,
contacts and
connections.
Check the iris setting.
No connection
established, no
image transmission.
The unit's configuration. Check all configuration
parameters.
Faulty installation. Check all cables, plugs,
contacts and
connections.