Filter
Top Products
30 en | Installation FlexiDomeHD 1080p IP Camera
AM18-Q0601 | v1.0 | 2012.01 Installation Manual Bosch Security Systems
5.7 Camera set-up
To help set up the camera for installation:
1. Connect a monitor to the 2.5 mm jack using the optional
monitor cable (S1460) which provides a CVBS signal (for
installation purposes only).
2. Disconnect the internal network cable.
3. Connect an external network cable with power (PoE).
4. After power-up, wait a little (less than 20 seconds).
5. Press the menu button. This stops the IP video stream and
enables the video analog output.
1. Menu button
2. Zoom (focal length) and Focus controls
(Position of these controls might differ depending on the
lens type. To use the full extension of the focus range, use
the lens slip ring or the auto back focus mechanism.)
PoE
S1460