Filter
Top Products
IP Camera 200 Series Installation | en 19
Bosch Security Systems Installation Manual AM18-Q0610 | v1 | 2012.02
3.7.1 Camera positioning
The camera position can be adjusted along three axes. When
adjusting ensure that the picture display on the monitor is level.
Set the camera to the desired position using the supplied Torx
screwdriver:
1. For vertical adjustment (1), loosen the locking screw and
move the camera housing to the desired angle. Tighten the
screw.
2. For horizontal adjustment (2), loosen the locking screw
and rotate the camera housing around the base. Tighten
the screw.
3. To obtain a horizontal horizon (3), rotate the camera body
as necessary to align the picture shown on the monitor.