Filter
Top Products
AutoDome Junior Installing a Recessed Mount | en 7
Bosch Security Systems, Inc. Installation Manual F.01U.168.034 | 3.0 | 2010.12
Figure 1.3 Attach Recess Mount to Ceiling
7. Tighten both clamps using the clamp drive screws
(installed on the assembly) and a #2 Phillips screwdriver.
NOTICE!
Over-torquing the ceiling clamps can damage the clamp or
ceiling. Only tighten the clamp until it contacts the ceiling and
you start to feel some resistance. If using a power screwdriver,
set the torque level to the lowest setting.
NOTICE!
If you need to install the the VJR-A3-SP Support Bracket, refer
to the guide included with the bracket. Once the bracket is
installed, continue with the next section.