Bushnell 204100 Film Camera User Manual


 
24
TROUBLE SHOOTING TABLE
If unit does not turn on - LCD does not illuminate:
• DepressPOWERbutton.
• Checkandifnecessary,replacebattery.
If unit powers down (display goes blank when attempting to power the laser):
• ebatteryiseitherweakorlowquality.Replacethebatterywithagoodquality3-voltlithiumbattery.
If target range cannot be obtained:
• MakesureLCDisilluminated.
• Makesurethatthepowerbuttonisbeingdepressed.
• Makesurethatnothing,suchasyourhandornger,isblockingtheobjectivelenses(lensesclosesttothetarget)
that emit and receive the laser pulses.
• Makesureunitisheldsteadywhiledepressingpowerbutton.
NOTE: e last range reading does not need to be cleared before ranging another target. Simply aim at the new target
using the LCD’s reticle, depress the power button and hold until new range reading is displayed.
Specifications, instructions, and the operation of these products are subject to change without notice.