Bushnell Tour V2 Film Camera User Manual


  Open as PDF
of 96
 
14
TROUBLE SHOOTING TABLE
If unit does not turn on - LCD does not illuminate:
•DepressPOWERbutton.
•Checkandifnecessary,replacebattery.
If unit does not respond to key presses, replace the battery with a good quality 3 volt lithium battery.
If unit powers down (display goes blank when attempting to power the laser):
•Thebatteryiseitherweakorlowquality.Replacethebatterywithagoodquality
3 -volt lithium battery.
If target range cannot be obtained:
• MakesureLCDisilluminated.
• Makesurethatthepowerbuttonisbeingdepressed.
• Makesurethatnothing,suchasyourhandornger,isblockingtheobjectivelenses
(lenses closest to the target) that emit and receive the laser pulses.
• Makesureunitisheldsteadywhiledepressingpowerbutton.
NOTE: The last range reading does not need to be cleared before ranging another target. Simply
aim at the new target using the LCD’s reticle, depress the power button and hold until new range reading is
displayed. Specifications, instructions, and the operation of these products are subject to change without notice.
201930_33 Tour V2 6LIM.indd 14 8/26/08 2:40:25 PM
 previous next