Filter
Top Products
3 Appending Dust Delete DataN
144
3
Photograph a solid-white object.
At a distance of 20 cm - 30 cm / 0.7 ft. - 1.0
ft., fill the viewfinder with a patternless,
solid-white object and take a picture.
X
The picture will be taken in the aperture-
priority AE mode with an aperture of f/22.
Since the image will not be saved, the
data can still be obtained even if there
is no card in the camera.
X When the picture is taken, the camera
will start obtaining the Dust Delete
Data. When the Dust Delete Data is
obtained, a message will appear.
Select [OK], and the menu will
reappear.
If the data was not obtained
successfully, a message to that effect
will appear. Follow the “Preparation”
procedure on the preceding page, then
select [
OK
]. Take the picture again.
After the Dust Delete Data is obtained, it is appended to all the JPEG
and RAW images captured thereafter. Before an important shoot, you
should update the Dust Delete Data by obtaining it again.
To erase dust spots automatically with the provided software, see the
PDF Software Instruction Manual on the CD-ROM.
The Dust Delete Data appended to the image is so small that it hardly
affects the image file size.
About the Dust Delete Data
Be sure to use a solid-white object such as a new sheet of white paper. If the
paper has any pattern or design, it may be recognized as dust data and
affect the accuracy of the dust deletion with the software.