Filter
Top Products
ENG-9
6. Lens Cap
The lens cap can be attached by pinching the
lock knobs and vertically aligning the lens cap
with the lens hood as shown in the diagram.
There is a gelatin filter holder at the rear of the
lens. Cut the gelatin filter to fit within the white
frames. Then insert the gelatin filter into the filter
holder.
7. Filter (Sold separately)
The recessed sections of the lens hood that the
cap locks on to are located at the front inside edge
of the top and bottom petals.
Lock knobs
The lens’s rear lens group moves back toward the
rear of the lens (camera side) the most when the
lens is set to the wide end. Therefore, in order to
prevent the rear lens element from making contact
with a lter (when installed), we recommend using
a lter only if the zoom ring is not set to the wide
end.
COPY