Canon 1D MK III Camera Accessories User Manual


 
4646
1
2
3
4
Introduction
Contents at
a Glance
Downloading
Images
Camera
Settings
Remote
Shooting
Reference
Preferences
Index
2
Specify settings.
Select [Auto], [Manual], or [Disable] from the list box.
When setting is completed, click the [Close] button to close the
[Recording settings] window.
An attenuator settings box appears when is
connected. In conditions with much loud sound, sound cracking
may occur even when shooting with [Sound recording] set to
[Auto] or [Manual]. If there is sound cracking, it is recommended
that you checkmark the attenuator function box to enable the
attenuator function.
Audio Recording/Audio Recording Level
[Auto]: The audio recording level is adjusted automatically
according to the volume of the sound. When [Auto] is
selected, you can only set the Wind filter function.
[Manual]: Function for advanced users. You can adjust the audio
recording level as desired.
Drag the audio recording level slider while checking the
level meter to adjust the audio recording level. When the
volume is loud, refer to the peak hold function (approx. 3
seconds) while adjusting so that the right side of “12” on
the level meter (-12 dB) lights intermittently. Exceeding
“0” results in sound cracking.
[Disable]: Sound is not recorded.
From the [Sound recording]
list box, select [Auto],
[Manual], or [Disable]
Wind filter function
Audio recording level
slider
Level meter
REBELT4i
650D
Wind Filter Function
When you want to reduce the sound of the wind recorded while
shooting outdoors, checkmark the Wind filter function box to enable
the Wind filter function. It will function only when using a built-in
microphone. However, when enabled, low bass sounds are also
partially reduced, and it is recommended that you remove the
check mark from this box in locations with no wind, to disable the
Wind filter function.
COPY