Filter
Top Products
CT1-7543-005 © CANON INC. 1986 2008.5
5. Hood
The lens hood can keep unwanted light out of the lens, and
also protects the lens from rain, snow, and dust.
EF24mm f/2.8
To attach the hood, align the hood’s attachment position
mark with the red dot on the front of the lens, then turn the
hood in the direction of the arrow until the lens’s red dot is
aligned with the hood’s stop position mark
, .
EF24mm f/2.8, EF28mm f/2.8, EF35mm f/2, EF50mm
f/1.0L USM, EF50mm f/1.8, and EF85mm f/1.2L USM
Press the buttons on both sides of the hood to attach
.
The hood can be reverse-mounted on the lens for storage.
• Part of the picture may be blocked if the hood is not
attached properly.
• When attaching or detaching the hood, grasp the base of
the hood to turn it. To prevent deformation, do not grasp
the rim of the hood to turn it.
6. Filters
You can attach filters to the filter mounting thread on the
front of the lens
.
• Only one filter may be attached.
• Use a polarizing Canon filter.
Filter Holder for the EF15mm f/2.8 Fish-eye
There is a gelatin filter holder at the rear of the lens
. Cut
the gelatin filter to fit within the white frames. Then insert
the gelatin filter into the filter holder.
Q
The lens length is measured from the mount surface to
the front end of the lens. Add 21.5 mm when including
the lens cap and dust cap. (Add 16.8 mm for EF15mm
f/2.8 Fish-eye)
Q
The size and weight listed are for the lens only, except as
indicated.
Q
Aperture settings are specified on the camera.
Q
All data listed is measured according to Canon
standards.
Q
Product specifications and appearance are subject to
change without notice.
Q
Case and hood not provided with some models.
Q
Filters sold separately.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Do not make any changes or modifications to the equipment
unless otherwise specified in the instructions. If such changes
or modifications should be made, you could be required to stop
operation of the equipment.
This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for
help.
This Class B digital apparatus complies with Canadian ICES-003.
Specifications
Angle of view
Lens
construction
Minimum
aperture
Max.
magnification
Min. focusing
distance
Filter diameter Max. diameter and length Weight Hood Case
Diagonal Vertical Horizontal
EF15mm f/2.8 Fish-eye 180° — — 7-8 22 0.14 × 0.2 m/0.7 ft. *1 73 × 62.2 mm (2.9” × 2.4”) 330 g/11.6 oz. *2 LP814
EF24mm f/2.8 84° 53° 74° 10-10 22 0.16 × 0.25 m/0.8 ft. 58 mm 67.5 × 48.5 mm (2.7” × 1.9”) 270 g/9.5 oz. EW-60 II LP811
EF28mm f/2.8 75° 46° 65° 5-5 22 0.13 × 0.3 m/1 ft. 52 mm 67.4 × 42.5 mm (2.7” × 1.7”) 185 g/6.5 oz. EW-65 II LP1011
EF35mm f/2 63° 38° 54° 5-7 22 0.23 × 0.25 m/0.8 ft. 52 mm 67.4 × 42.5 mm (2.7” × 1.7”) 210 g/7.4 oz. EW-65 II LP1011
EF50mm f/1.0L USM 46° 27° 40° 9-11 16 0.11 × 0.6 m/2 ft. 72 mm 91.5 × 81.5 mm (3.6” × 3.2”) 985 g/34.7 oz. ES-79 II LP1219
EF50mm f/1.8 46° 27° 40° 5-6 22 0.15 × 0.45 m/1.5 ft. 52 mm 67.4 × 42.5 mm (2.7” × 1.7”) 190 g/6.7 oz. ES-65 III LP1014
EF85mm f/1.2L USM 28°30’ 16° 24° 7-8 16 0.11 × 0.95 m/3.2 ft. 72 mm 91.5 × 84 mm (3.6” × 3.3”) 1025 g/36.2 oz. ES-79 II LP1219
*1 Built-in gelatine filter holder
*2 Built-in
COPY