Canon 2510A003 Camera Lens User Manual


  Open as PDF
of 2
 
CT1-8536-003 1208SZ © CANON INC. 2006
●❽
●❾
●󱀓
●󱀔
5. Filters
You can attach filters to the filter mounting thread on the front of
the lens.
• UseapolarizingCanonfilter.
Filter holder for the EF14mm f/2.8L USM
Thereisagelatinfilterholderattherearofthelens.Cutthegelatin
filter to fit within the white frames. Then insert the gelatin filter into
the filter holder
❽
.
6. Hood
Thelenshoodcankeepunwantedlightoutofthelens,andalso
protectsthelensfromrain,snow,anddust.
EF50mm f/1.4 USM
Fitthehoodtothehoodmount,thenturnitinthedirectionofthe
arrow to attach it securely.
EF20mm f/2.8 USM, EF24mm f/1.4L USM, EF28mm f/1.8 USM,
and EF35mm f/1.4L USM
Toattachthehood,alignthehood’sattachmentpositionmark
withthereddotonthefrontofthelens,thenturnthehoodinthe
directionofthearrowuntilthelens’sreddotisalignedwiththe
hood’sstoppositionmark
❾
.
EF85mm f/1.8 USM and EF100mm f/2 USM
Press the buttons on both sides of the hood to attach
󱀓
.
EF200mm f/2.8L USM
Pullthehoodoutfromthefrontofthelensuntilitstops
󱀔
.
Lenses other than the EF14mm f/2.8L USM and EF200mm f/2.8L
USM
The hood can be reverse-mounted on the lens for storage.
• Partofthepicturemaybeblockedifthehoodisnotattached
properly.
• Whenattachingordetachingthehood,graspthebaseofthe
hoodtoturnit.Topreventdeformation,donotgrasptherimof
the hood to turn it.
n
The lens length is measured from the mount surface to the front
endofthelens.Add21.5mmtoincludetheE-58U/E-72Ulens
capanddustcap,and24.2mmfortheE-58II/E-72II.
n
Thesizeandweightlistedareforthelensonly,exceptas
indicated.
n
Aperturesettingsarespecifiedonthecamera.
n
AlldatalistedismeasuredaccordingtoCanonstandards.
n
Productspecificationsandappearancearesubjecttochange
without notice.
n
Caseandhoodnotprovidedwithsomemodels.
n
Filterssoldseparately.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Do not make any changes or modifications to the equipment
unless otherwise specified in the instructions. If such changes
or modifications should be made, you could be required to stop
operation of the equipment.
This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
• Consultthedealeroranexperiencedradio/TVtechnicianfor
help.
This Class B digital apparatus complies with Canadian ICES-003.
Specifications
Angle of view
Lens
construction
Minimum
aperture
Max.magnificationandfieldofview
Min. focusing
distance
Filter
diameter
Max.diameterandlength Weight Hood Case
Diagonal Vertical Horizontal
EF14mmf/2.8LUSM 114° 81° 104° 10-14 22 0.10X/246×375mm(9.7”×14.8”) 0.25m/0.82ft. *1 77×89mm(3.0”×3.5”) 560g/19.6oz. *2 LP1016
EF20mmf/2.8USM 94° 62° 84° 9-11 22 0.14X/176×264mm(6.9”×10.4”) 0.25m/0.82ft. 72mm 77.5×70.6mm(3.1”×2.8”) 405g/14.2oz. EW-75II LP1214
EF24mmf/1.4LUSM 84° 53° 74° 9-11 22 0.16X/150×227mm(5.9”×8.9”) 0.25m/0.82ft. 77mm 83.5×77.4mm(3.3”×3.1”) 550g/19.4oz. EW-83DII LP1214
EF28mmf/1.8USM 75° 46° 65° 9-10 22 0.18X/139×212mm(5.5”×8.3”) 0.25m/0.82ft. 58 mm 73.6×55.6mm(2.9”×2.2”) 310g/10.9oz. EW-63II LP814
EF35mmf/1.4LUSM 63° 38° 54° 9-11 22 0.18X/136×206mm(5.4”×8.1”) 0.3m/0.98ft. 72mm 79×86mm(3.1”×3.4”) 580g/20.5oz. EW-78C LP1214
EF50mmf/1.4USM 46° 27° 40° 6-7 22 0.15X/164×249mm(6.5”×9.8”) 0.45m/1.48ft. 58 mm 73.8×50.5mm(2.9”×2.0”) 290g/10.2oz. ES-71II LP1014
EF85mmf/1.8USM 28°30’ 16° 24° 7-9 22 0.13X/191×287mm(7.5”×11.3”) 0.85m/2.79ft. 58 mm 75×71.5mm(3.0”×2.8”) 425g/14.9oz. ET-65III LP1014
EF100mmf/2USM 24° 14° 20° 6-8 22 0.14X/175×262mm(6.9”×10.3”) 0.9m/2.95ft. 58 mm 75×73.5mm(3.0”×2.9”) 460g/16.1oz. ET-65III LP1014
EF200mmf/2.8LUSM 12° 7° 10° 7-9 32 0.16X/152×226mm(6”×8.9”) 1.5m/4.92ft. 72mm 83×136.2mm(3.3”×5.4”) 790g/27.7oz. *2 LH-D18
*1 Built-in gelatine filter holder
*2 Built-in
C OPY
 previous