Filter
Top Products
Photos • 51
Push the joystick ( ) and hold it
pressed down to run quickly through
the still images.
1 If the joystick guide does not
appear on screen, press to
display it.
2 Push the joystick ( ) toward .
3 Select ( ) [ JUMP 10 IMAGES]
or [ JUMP 100 IMAGES].
4 Jump ( ) the number of images
selected and press .
You can press again to hide the
joystick guide.
IMPORTANT
• Observe the following precautions while
the card access display ( ) appears
on screen, and when the CARD access
indicator is on or flashing. Failing to do
so may result in permanent data loss.
- Do not subject the camcorder to
vibrations or strong impacts.
- Do not open the memory card slot
cover and do not remove the memory
card.
- Do not disconnect the power source or
turn off the camcorder.
- Do not change the position of the
/ switch or the operating mode.
• The following may not be displayed
correctly.
- Images not recorded with this
camcorder.
- Images edited on a computer.
- Images whose file names have been
changed.
Slideshow
[ SLIDESHOW] [START]
• Images are played back one after
another.
• Press to stop the slideshow.
Index Screen
1 Move the zoom lever toward W.
The still images index screen
appears.
2 Select ( , ) an image.
• Move the green selection frame to
the image you want to view.
• If you have a lot of still images, you
may find it easier to browse entire
index pages instead. Move the
zoom lever toward W to extend the
green selection frame to the whole
page, and move ( ) between
index pages. Move the zoom lever
toward T to return to moving
between single images.
3 Press .
The index screen closes and the
selected image is displayed.
TO RUN THROUGH THE STILL IMAGES
TO SKIP 10 OR 100 STILL IMAGES
FUNC.
( 19)
FUNC.
FUNC.
D126_NTSC_PAL_E.book Page 51 Tuesday, January 15, 2008 12:15 PM