Canon 6151B001 Digital Camera User Manual


 
Troubleshooting
158
No AF frames are displayed and the camera does not focus when the shutter
button is pressed halfway.
To have AF frames displayed and the camera focus correctly, try composing the shot
with higher-contrast subject areas centered before you press the shutter button
halfway. Otherwise, try pressing the shutter button halfway repeatedly.
Subjects in shots look too dark.
Set the flash mode to h (p. 100).
Adjust brightness by using exposure compensation (p. 84).
Adjust contrast by using i-Contrast (pp. 88, 119).
Use spot metering or AE lock (pp. 85, 86).
Subjects look too bright, highlights are washed-out.
Set the flash mode to ! (p. 60).
Adjust brightness by using exposure compensation (p. 84).
Use spot metering or AE lock (pp. 85, 86).
Reduce the lighting on subjects.
Shots look too dark despite the flash firing (p. 50).
Shoot within flash range (see “Specifications” in the Getting Started guide).
Increase the ISO speed (p. 87).
Subjects in flash shots look too bright, highlights are washed-out.
Shoot within flash range (see “Specifications” in the Getting Started guide).
Set the flash mode to ! (p. 60).
White dots or similar image artifacts appear in flash shots.
This is caused by light from the flash reflecting off dust or airborne particles.
Shots look grainy.
Lower the ISO speed (p. 87).
High ISO speeds in some shooting modes may cause grainy images (p. 87).
Subjects are affected by red-eye (p. 63).
Set [Lamp Setting] to [On] (p. 66) to activate the red-eye reduction lamp (p. 4) in flash
shots. Note that while the red-eye reduction lamp is on (for about one second), it is not
possible to shoot, because the lamp is counteracting red-eye. For best results, have
subjects look at the red-eye reduction lamp. Also try increasing the lighting in indoor
scenes and shooting at closer range.
Edit images using red-eye correction (p. 120).
Recording to the memory card takes too long, or continuous shooting is
slower.
Use the camera to perform low-level formatting of the memory card (p. 127).
Shooting settings or FUNC. menu settings are not available.
Available setting items vary by shooting mode. Refer to “Functions Available in Each
Shooting Mode”, “FUNC. Menu”, and “Shooting Menu” (pp. 166 – 173).
COPY