Filter
Top Products
29
Installing and Removing the CF Card
1
Open the cover.
Set the power switch to <2>.
Check that “Recording...” is not
displayed on the LCD monitor.
Make sure the access lamp is off,
then open the cover.
2
Remove the CF card.
Press the CF card eject button.
X The CF card will come out.
Close the cover.
Removing the Card
Access lamp
A blinking access lamp indicates that data is being transferred, read,
written, or erased on the CF card. While the access lamp is lit or
blinking, do not do any of the following. Doing so may damage the
image data. It may also damage the CF card or camera.
· Opening the CF card slot cover.
· Removing the battery.
· Shaking or banging the camera around.
If the CF card already contains recorded images, the image number
might not start from 0001. (p.96)
If a CF card-related error is displayed, see page 38.
Compared to CF cards, hard disk-type memory cards are more
vulnerable to vibration and physical shock. If you use a such a card, be
careful not to subject the camera to vibration or physical shock especially
while recording or displaying images.
On the menu, if you set [z Shoot w/o card] to [Off], it will prevent
shooting without a CF card. (p.94)