Filter
Top Products
Not For
Resale
–
Free Download at http://www.joe
-
chan.com/manuals
Battery Check
Check the mercury battery after loading it. Especially
when loading a new battery, be sure to check the power
level.
Set the film speed scale at ASA 100 and the shutter
speed dial at "2000". To set the film speed, lift up the
outer ring on the shutter speed dial and turn. (See page
31.)
A positive check cannot be made if other settings are
used.
Turn the meter switch, situated on the back side of the
camera near the film rewind crank, to the "C" index
mark.
If the meter needle inside the viewfinder swings into the
meter index, the battery has sufficient power. If the
needle stays below the meter index, the voltage is
insufficient and the battery must be replaced.
Life of the battery in normal use is approximately
one year.
When using the camera, be sure to turn the meter
switch to "ON".
1
2
3
4
17