Filter
Top Products
79
E
Editing
1. Connect the camera to the VCR (p. 30), load recorded tapes into both the camcorder
and VCR.
• Make sure the REC/SAVE tab on the tape has been slid to REC (closed position).
2.
Slide the POWER switch to VCR.
3. On the VCR, locate a point three seconds before the scene to be inserted (to ensure a
stable picture). Set the VCR to playback pause mode.
4. On the camera, locate the recording start point. Set the camera to playback pause
mode.
• You can use the camera’s `, 1, e, a and 3 buttons or special playback functions just as when
in playback mode.
5. Press the A/V INSERT button on the wireless controller.
• A/V INSERT and 2a appear in the display.
6. On the VCR, play back the tape.
7. When you get to the starting point of the scene to be inserted, push the pause button on
the camera.
• A/V insert starts.
• 2a changes to 2.
8. When you get to the point where you want to stop inserting, press the stop button of the
camera.
• Inserting stops and A/V INSERT disappears from the display. The camera returns to stop mode.
• If instead of pressing 3 (STOP) you press a (PAUSE), the camera returns to the A/V insert pause
mode.
• If you set the zero set memory at the position on the tape where you want to stop inserting, every
time you return to that point, the camera will cancel its A/V inserting and enter stop mode.
9. Press the stop button of the VCR.
Scene to be inserted
Insert start point Insert end point
The playback tape
Before inserting
The tape in the camera
The video and audio of the new scene replace that of the old.
The tape in the camera
After inserting