Filter
Top Products
25
ENGLISH
Controlling the Camera from the Wireless Controller
To store a position
1.
Set the camera head angle, zoom position and
brightness.
■ The focus setting is not stored.
2. Press the button.
■ The LED on the camera blinks green (at 0.5-second
intervals).
■ Press the button again to cancel the operation.
3. Press a button from to .
■ When the position has been stored, the LED on the camera
stops blinking and remains green.
■ Any existing preset information is overwritten.
To restore a preset position
Press a button from to .
■ The VC-C50i/VC-C50iR returns to the stored camera head
angle, zoom position and brightness level.
321
AF
654
MF
987
0
MENUID
HOME
Fn
BRIGHT
ON SCREEN
∞
SET/OK CANCEL
ZOOM
T
W
● During preset operations, the camera pans and tilts at the speeds set for pan/
tilt operation in the setting menu. When the [AUTO] setting is selected, the
head moves at the maximum speed (→ P.30).
● Stored preset position information can only be overwritten. Stored preset
positions cannot be erased. However, the preset position is cleared if the
COMMAND mode is changed (→ P.33).
● If the camera is in manual focus mode, the focus may be incorrect when a
preset position is restored. In this event, set the camera to auto-focus mode
or focus the camera manually.
MEMO
Storing a Preset Camera Position (PRESET)
This section describes how to store a camera head angle, zoom position and brightness level.
Up to nine (1 to 9) preset positions can be stored. Switching the power off or the camera off
does not erase the stored preset positions.