Filter
Top Products
CONNECTING TO EXTERNAL EQUIPMENT
E-131
IMPORTANT!
• The external flash connected to the external flash
sync terminal always fires. To record an image without
using external flash, disconnect the sync cable from
the terminal or turn off external flash unit power.
• After recording an image, check it on the monitor
screen. If it is not what you expected, use the controls
on the external flash unit to adjust flash intensity, and
adjust the aperture and ISO sensitivity settings on the
camera. Note that you cannot control external flash
unit intensity using camera settings.
• Close up images often tend to be overexposed. If you
are having overexposure problems, try adjusting the
aperture and ISO sensitivity settings of the external
flash unit and the camera. You can also try using the
camera’s built in flash to correct for overexposure.
• Note that the camera’s built in flash fires whenever its
Flash Mode setting is something other than (Off).
The camera’s sensitivity is fixed at ISO 80 when the
built-in flash is turned on.
• Improper installation of an external flash unit can
cause it to fire unexpectedly or to misfire. Make sure
you install the external flash unit correctly.
4.
Turn on camera power and make the required
camera settings.
• Exposure Mode: M (Manual Exposure)
• Shutter Speed: Around 1/60 (Actual setting should be
in accordance with aperture setting.)
• For maximum brightness of areas that are not reached
by flash illumination, use the camera’s maximum ap-
erture opening (F3.2).
• White Balance: Sunlight
• Flash Mode: (Off)
5.
Turn on the external flash unit and set it up for
the camera’s aperture (F) value (page E-83)
and sensitivity value (page E-85).
• Depending on shooting conditions, proper exposure
may not be obtained even if you properly set the auto
aperture (F) value and ISO sensitivity of the flash unit
to match those of the camera. If this happens, adjust
the aperture value and ISO sensitivity settings of the
flash unit and camera.