Filter
Top Products
71
Advanced Settings
. To change Auto Shutter trigger sensitivity (Sensitivity)
1. Use [8] and [2] to select “Sensitivity” and then press [6].
2. Use [4] and [6] to select the sensitivity setting you want, and then
press [SET].
• You can select any one of three sensitivity levels, from ø (Lowest) to
œ (Highest).
• With the œ (Highest) setting, the auto shutter release is triggered relatively
easily. Auto shutter release triggering becomes more difficult with the ø
(Lowest) setting, but recorded images have the least blur. Experiment with
Auto Shutter trigger sensitivity settings to find the one that work best for you.
. Using Auto Shutter in Combination with Continuous Shutter
The following describes how Auto Shutter works while used in combination with
Continuous Shutter (page 66).
Tips for Better Auto Shutter Snapshots
• Using Auto Shutter in combination with Anti Shake (page 73) reduces the chance
of image blur even more.
• While recording with Detect Blur or Detect Smile, keep the camera as still as
possible until the recording operation is complete.
IMPORTANT!
• If the camera remains in Auto Shutter standby without releasing the shutter, you
can record an image by pressing the shutter button all the way down again.
• Detect Blur and Detect Panning may not produce the desired effect when shooting
in an area where dim lighting requires a slow shutter speed, or when the subject is
moving extremely quickly.
• Since facial expressions differ from individual to individual, you may experience
problems with getting the camera to release the shutter while Detect Smile is being
used. If this happens, change the trigger sensitivity setting.
• The Auto Power Off (page 146) trigger time is fixed at five minutes while the
camera is in Auto Shutter standby. Sleep (page 145) is disabled while Auto Shutter
being used.
• To cancel Auto Shutter recording while Auto Shutter is being performed (indicated
by “0 Auto” flashing on the monitor screen), press [SET].
• The “Ë Tracking” setting for the AF area cannot be used while Detect Blur or
Detect Panning is selected for the Auto Shutter setting (page 40).
With CS: Normal
Speed CS, CS: 4 fps,
and CS: 10 fps
The camera will go back into Auto Shutter standby and be
ready to shoot again each time it is triggered. To stop an
ongoing Continuous Shutter operation, wait until “0 Auto”
is flashing on the monitor screen, and then press [SET].
With CS: Flash
3 continuous shutter images will be shot with flash when
Auto Shutter is triggered.