Casio EX-Z5 Digital Camera User Manual


 
APPENDIX
236
4.
With the camera
positioned with the
monitor screen facing
forward as shown in
the illustration, place it
onto the USB cradle.
Do not place the camera
onto the USB cradle
while it is turned on.
The [CHARGE] lamp on
the USB cradle should
turn red, indicating that charging has started. When
charging is complete, the [CHARGE] lamp will turn
green.
It takes about 130 minutes to achieve a full charge.
Actual charging time depends on current battery
capacity and charging conditions.
5.
After charging is complete, remove the
camera from the USB cradle.
IMPORTANT!
Use only the battery charger (BC-11L) or the USB
cradle (CA-32) to charge the special NP-20
rechargeable lithium ion battery. Never use any other
charging device.
Use only the bundled AC adaptor. Never use any
other type of AC adaptor. Do not use optionally
available AD-C30, AD-C40, AD-C620 and AD-C630
AC adaptors with this camera.
Make sure that the camera connector of the USB
cradle is securely inserted into the cameras
connector as far as it will go.
The [CHARGE] lamp may remain amber colored and
the charge operation may not start right away if you
try to charge immediately after using the camera
(which causes battery to become warm) or when it is
too hot or too cold where you are performing the
charge operation. If this happens, simply wait until
the battery reaches normal temperature. The
[CHARGE] lamp will turn red and charging will start
when the battery temperature returns to the
allowable charging temperature range.
[CHARGE] lamp