Filter
Top Products
v2.0 - English
27
Snapshot
Individual images can be displayed in different resolutions. To select the resolution,
append the corresponding parameter to the command snap.jpg:
Ex: 192.168.0.1/snap.jpg
Ø Snap.jpg?JpegSize=S 176 x 144 pixels
Ø Snap.jpg?JpegSize=M 352 x 288 pixels (default value)
Ø Snap.jpg?JpegSize=XL 704 x 576 pixels
The connection between two IP addresses can be checked using the command ping. You
can thus check whether the device in the network is active.
Ø Open the DOS input window and enter the command ping followed by the IP
address of the device. (Ex: ping 192.168.0.1)
Ø When the device is found, you receive in response: Reply from ..., followed by the
number of bytes transmitted and the transmission time in milliseconds (ms). Other
messages, such as a time out or unreachable, this indicates that the device cannot
be addressed via the network. This can have the following causes:
The device is not physically connected to the network. In this case, check the
connecting leads, and the link lights on all devices. Or, perhaps the device is not
correctly integrated into the network with its settings. Check the IP address, the
subnet mask and the gateway IP.
Reset
In order to activate the new configuration the system must be rebooted by
entering the current IP address followed by a reset operation:
ex. http://192.168.0.1/reset
Updated Firmware Download
You can find updated firmware for ZN-L8000 cameras at the following URL:
http://www.cbc-europe.it/cctv/download
SERVICE