Creda 85301 Photo Printer User Manual


 
Quartz Electronic
THERMOSTAT MODELS 85311 / 85312 / 85313 / 85314 / 85315
The Panel - How it Works
Heating elements within the metal casing warm its front face for direct radiation into the room and a gentle circulation
of warm air around the room. A built-in thermostat with its adjustment knob towards the bottom of the right hand edge
of the panel, controls the room temperature by detecting this from the air passing upwards through the panel.
NOTE - Should your heater fail to come on when the thermostat knob is at a low setting, this may be due to the room
temperature being higher than the thermostat setting.
THERMOSTAT AND PROGRAMME TIMER MODELS
85301 / 85302 / 85303 / 85304 / 85305
An electric timer by which the heating panel can be switched on and off
automatically at predetermined times, is built into the top right hand corner of the
panel. If you are making use of this feature, you must, of course, leave the power
supply connected to the panel from the wall power point otherwise the timer will not
run. To select the automatic periods of heating, make sure that the timer dial is set to
read the correct time of day against its index mark (WARNING: TIME DIAL IS
CAPABLE ONLY OF BEING ROTATED CLOCKWISE). Push the segments
around the timer dial inwards at the appropriate times that you wish the panel to be
'ON'. This reveals an orange background. Each segment represents a
twenty minute (
1
/
3
of an hour) period.
At the bottom of the control cover is a screwdriver operated lock. Other than actually
adjusting the controls, this lock should be kept in the locked position. Adjacent to the
timer dial is a switch with three settings:
Select this setting for the timer to give automatic control of the panel.
The panel is permanently switched off, although the power is still connected to it.
Provided the wall power point is switched on, at this setting the panel provides
continuous heating.
SAFETY:
A thermal cut-out is fitted to all models, which will switch off the heater if, for any reason, it overheats. Should the cut-out
operate, determine the reason for over-heating before resetting the cut-out. To re-set the cut-out, switch off and
disconnect the electricity supply to the heater for a few minutes, after which time normal operation may be resumed.
DO NOT SPILL LIQUIDS ONTO THE APPLIANCE. IF YOU DO, SWITCH THE HEATER OFF AND GET A QUALIFIED
ELECTRICIAN TO CHECK IT.
DO NOT POKE OBJECTS THROUGH THE GRILL OR VENTILATION SLOTS.
THE SURFACES OF THIS HEATER WILL GET HOT THEREFORE WHEN YOUNG CHILDREN, ELDERLY OR INFIRM
PEOPLE ARE PRESENT THE APPLIANCE MUST BE ADEQUATELY GUARDED.
DO NOT USE POLISHES ON THE HEATER OR ON FURNITURE NEAR IT. The hot interior of the heater can produce
paraffin smells from the polish vapours which may last for a number of hours. To clean the heater switch off the mains
supply and wipe over with a damp cloth.
DO NOT DRAPE CLOTHING OR CURTAINS OVER THE HEATER OR STAND ANYTHING ON OR NEAR TO IT.
ENSURE THAT NOTHING IS PLACED AGAINST OR IN CONTACT WITH THE HEATER CASING. An air space of at
least 50mm (2") must be maintained around the heater. Any shelf or curtain installed above the heater must have a
minimum gap of 150mm (6") between the heater and the shelf or curtain.
WARNING: IF THE HEATER IS COVERED THERE IS A RISK OF FIRE. DO NOT SIT OR STAND ON THE HEATER.
DO NOT ATTEMPT TO REMOVE THE HEATER FROM ITS WALL BRACKET. DOING SO COULD CAUSE PERSONAL
INJURY OR STRESS TO THE ELECTRICAL CABLE AND ITS CONNECTIONS.
DO NOT ATTEMPT TO REPAIR THE HEATER YOURSELF. In case of breakdown or other failure, switch off the heater at
the wall switch and consult your supplier or Creda Service Centre. Always ensure that the heater is switched off at the wall
switch and the fuse removed before any repair is carried out.
DO NOT USE THIS HEATER FOR ANY PURPOSE OTHER THAN AS A ROOM HEATER.
Applied Energy Products Ltd., Morley Way, Peterborough PE2 9JJ
Tel. +44(0)8709-000430 Fax. +44(0)8709-000530
For details of spares, service and guarantee see separate leaflet. INCPUKRNGE/1
Splashproof
This appliance is not intended for use by young children or infirm persons
without supervision.
Young children should be supervised to ensure that they do not play with
the appliance.