Daewoo 65M200 Camcorder User Manual


 
IMPORTANT SAFETY INSTRUCTIONS
2
SAFETY POINTS YOU SHOULD KNOW ABOUT
YOUR ASPECT PROJECTION MONITOR
Our reputation has been built on the quality, performance, and ease of service of ASPECT Projection Monitors.
Safety is also foremost in our minds in the design of these units. To help you operate these products properly, this
section illustrates safety tips which will be of benefit to you. Please read it carefully and apply the knowledge you
obtain from it to the proper operation of you ASPECT Projection Monitor.
Please fill out your warranty card and mail it to ASPECT. This will enable ASPECT to notify you promptly in the improb-
able event that a safety problem should be discovered in your product model.
Follow all warnings and instructions marked on this Projection Monitor.
The lightning flash with arrowhead symbol, within an equilateral tri-
angle, is intended to alert the user to the presence of uninsulated
“dangerous voltage” within the product’s enclosure that may be of a
sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle, is intended to
alert the user to the presence of important operating and mainte-
nance (servicing) instructions in the literature accompanying the
appliance.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS
TO RAIN OR MOISTURE.
THE PROJECTION MONITOR SHOULD NOT BE EXPOSED TO DRIPPING OR SPLASHING.
OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHOULD NOT BE PLACED ON THE
PROJECTION MONITOR.
NOTE: • There are no user serviceable parts inside the Projection Monitor.
• Model and serial numbers are indicated on back side of the Projection Monitor.
POWER SOURCE
THIS
PROJECTION MONITOR
IS DESIGNED TO OPERATE ON 120 VOLTS 60Hz, AC CURRENT. INSERT
THE POWER CORD INTO A 120 VOLT 60Hz OUTLET.
TO PREVENT ELECTRIC SHOCK, DO NOT USE THE PROJECTION MONITOR’S (POLARIZED) PLUG
WITH AN EXTENSION CORD, RECEPTACLE, OR OTHER OUTLET UNLESS THE BLADES AND GROUND
TERMINAL CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
NEVER CONNECT THE
PROJECTION MONITOR
TO 50Hz, DIRECT CURRENT, OR ANYTHING OTHER
THAN THE SPECIFIED VOLTAGE.
CAUTION: Never remove the back cover of the Projection Monitor as this can expose you to very high voltages and
other hazards. If the Projection Monitor does not operate properly, unplug the Projection Monitor and call
your authorized dealer or service center.
CAUTION:
Adjust only those controls that are covered in the instructions, as improper changes or modifications
not expressly approved by ASPECT Brand Electronics could void the user’s warranty.
MODIFICATIONS:
The FCC requires the user to be notified that any changes or modifications made to this
device that are not expressly approved by ASPECT Brand Electronics may void the user’s
authority to operate the equipment.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
As an ENERGY STAR
®
Partner, Hitachi, Ltd. has determined that this product meets the ENERGY STAR
®
guidelines for energy efficiency.