Filter
Top Products
Part 8 – Setting up the DVR to Playback
From the Main Menu select SEARCH to display the Video Search Menu shown below:
In the playback window you can play video Forward at 2x, 4x, and 8x speeds, Slow play at 1/2x, 1/4x, and 1/8x, or
normal play, pause and play frame by frame using the playback control bar, and adjust volume by clicking or sliding
tune control bar. When playback has finished, system will return to previous menu.
The Motion detection Menu has three sections, including
Channel Status, Sensitivity and Motion area.
STATUS: This option allows you enable motion detection
on any channel.
SENSITIVITY: This option allows you to set sensitivity
level of motion detection from 1 to 4, with 4 being the
highest.
Next, click on the MD AREA SETUP button, which will
display the picture on the left. This option allows you to
select the area you want to be sensitive to motion. The
area in red is sensitive to motion. You can set this area by
using the mouse or REV, FWD, and SEL keys on the
front panel. Once you have set the area, right click with
the mouse or push the ESC key to save the setting. After
you have set all of the cameras, click on the Apply button
to save the settings.
Searched playback:
If you input a specific date and click Search, you will find all the
recordings for that day. When you select an item, you will
playback the recordings in 4 channel mode; or, click [File list]
button to display File list interface, where you can playback or
backup the file you selected. See File List heading below.