Filter
Top Products
10D-Link DCS-3415 User Manual
Section 2 - Hardware Installation
Hardware Installation
Connect the Ethernet Cable
Connect an Ethernet cable to the network cable connector located on the Network
Camera’s back panel and attach it to the network.
Attach the External Power Supply
Attach the external power supply to the DC power input connector located on the Network
Camera’s back panel (labeled DC 12V) and connect the other end to an AC power
outlet.
Note: The LED on the network camera will turn green, when you have a proper connection. The light
might go on and off and your computer may show an intermittent loss of connectivity, this is normal until
you have configured your Network Camera.
Connect Using Power-Over-Ethernet
Once you connect an Ethernet cable to your PoE switch or adapter, the Power LED on
the DCS-3415 will turn green to indicate a proper connection.