Edimax Technology IC-9000 Security Camera User Manual


 
5. Hardware Installation
Please follow the following instructions to set up the IC-9000:
1. Please connect the IP CAM accessories to the body of the
IC-9000 correctly, including the bracket, power adapter and
Ethernet cable, as shown in the above figure.
2. Connect the other end of the Ethernet cable to the home
network or office network. Usually, this Ethernet cable is plugged
into a home NAT/router device or an Ethernet switch if in the
office, as shown in the above figure.
3. Since the default settings of the IP CAM use DHCP function and
very often there is a DHCP server on most of the Home/office
network, the IP CAM should be connected to the Internet
immediately