Elinchrom BX100 Camera Accessories User Manual


 
5
3
1
6
11
12
The units Style BX (Multivoltage) are adapted for operation on 90 - 260V/50 - 60Hz.
Before connecting for the rst time, check to make sure that your Modelling lamp coincides
with the voltage line. They must always be connected to an earthed ( grounded) mains supply.
All Style BX units have a bayonet mount and locking ring reector tting, for xing all Elinchrom and
Prolinca accessories.
Mount the unit securely to a suitable stand or support.
Remove the black protective cover (note: rst turn the locking ring A as shown, then rotate the
black cap cover B in the same direction). Fitting a reector or accessory is the reverse of this action.
DO NOT operate the unit without rst removing the black protective cover.
1.Check that the modelling lamp voltage is correct.
2.Check that the mains switch (3) is in the OFF ("O" position).
3.Insert mains cable to the MAINS INLET (1) and connect to a FULLY EARTHED OUTLET
4.Using the mains SWITCH (3) and switch the unit ON ("I" position).
5.Connect the synchro cord on the socket (6).
6.Select the power with the touch pad (11 - 12)
Operating instructions
C
A
B
Locking ring
Handle
Tilthead with locking
umbrella holder
Protective
cover
(26124)
Before you start !