Filter
Top Products
B/W, Color and Low Lux Color Cameras
Model EL25BWCAMKT
Model EL25CCAMKT
Model EL25DVRCAMKT
Disconnect power to the unit!
Unlock and open the unit.
Unplug the wire harness from LED board, remove and discard call button board. (3 screws)
Keep “O” ring from old board and place on new board.
Plug the other end of the coaxial cable into a monitor or home entertainment system.
Reconnect the power to the EL25 and the camera picture will appear.
NOTE: If the EL25 is connected to a home entertainment system, the home entertainment
system must be switched to video input.
1
2
3
4
5 6
7
Camera Module
Replaces the LED Board.
Replace black plastic lens with the clear
lens. Keep rubber “O” ring in place.
Install the camera module (3 screws). Reconnect the
LED board wire harness to the camera module.
Feed coaxial cable (not provided)
through the conduit hole in the
back mounting plate of the EL25.
Carefully connect a BNC coaxial
connector to the back of the
camera module. Close and lock
the unit.
Vertically Mounted EL25s ONLY:
The camera lens board must be
repositioned 90 degrees
counterclockwise before the
above steps can be performed.
Repositioned camera lens board (Portrait) ready
for installation in a vertically mounted EL25.
Note: Carefully remove the
2 mounting screws in a
secure flat area to avoid
losing the parts!
Caution!
A static discharge can
DAMAGE circuit boards.
for the EL25 telephone entry/access control system
+
LED
Board
Wire
Harness
H2
100A
UD
H2
100A
UD
H2
100A
UD
H2
100A
UD
90˚
LED
Board
Call Button
Board
+
LED Board
2