Filter
Top Products
to move back and forth freely (Fig.4-2 & 4-3). Make sure the tubes are not twisted and are straight (Fig.4-3).
Fig.4-1 Fig.4-2 Fig.4-3
d. Turn on the printer and make sure the system moves smoothly.
5. Refilling Ink
When the ink levels reach the indicator margin, (sticker on the ink tank with red line) the ink tank system
has reached its low level line and needs to be refilled.
Follow these steps:
1. Gently remove the air breather plugs in order to have more filling room.
2. Remove the plugs off of the refilling hole and refill the proper color of ink into the corresponding tank. (Fig 5-2)
Use towel to wipe off any spillage.
3. Make sure you use the specially designed ink Low Foam Ink for the CI System as they are specifically designed for
optimal results.
NOTE: When removing the CIS, remove cartridges and put tape or a napkin over ink exit hole.
Printer and ink tank MUST remain at the same level (not higher and not lower).
Fig 5-1 Fig 5-2
6. Attention:
1. After installing the CI System, do not remove the cartridges unless it is necessary. If cartridges are removed,
immediately place cartridges upside down with ink exit holes facing up to avoid leaking. If cartridges are
removed for more than an hour, please cover ink exit holes with tape.
2. When you are printing do not move the ink tank up or down. Keep it stable and at the same level as the printer.
3. Store at 15-35 degrees Celsius.
4. The ink and cartridge flow have been designed and tested to function as a system. We recommend you use the
specially designed ink Low Foam Ink in the CIS for optimal results.
7. Caution:
1. Do not ingest ink and keep out of reach of children.
2. Do not leave under sunlight or in extreme weather conditions.
3. Do not drop ink tank or handle roughly.