Filter
Top Products
EN-8
Preliminary check of the case
Before installing the digital camera in the case, make sure that there is no water leakage.
1
Check the outside of the waterproof case to make sure that there are no
cracks or faults with it.
2
Open the waterproof case using the special pick (included).
special pick (included)
➀ Release the lock of the open/close
knob.
➁ Turn the open/close knob in the
direction of the “OPEN” arrow to open
the waterproof case.
3
Check the inside of the waterproof case for the following:
• Cracks (especially around the O-ring)
• Correct seating of the O-ring (For
correct installation of the O-ring, see
page 24.)
• That the O-ring has no scratches
or cracks, or that it is oddly shaped,
twisted, detached, etc.
• Sand or foreign particles stuck to the
O-ring
Make a preliminary submersion test on the waterproof case before
positioning the digital camera
open/close knob
O-ring
When opening or closing the waterproof
case, take care not to catch your fingers
or palm in the case.
You can also use the adjuster of the strap
if you do not have the special pick (pg. 15).