Filter
Top Products
44
TROUBLE SHOOTING
During operation
1 Replace the battery with a new one.
2 Press the POWER button.
3 The flash is charging. Wait until “
” stops blinking
and is displayed. (The flash takes approx. 6 sec-
onds to charge.)
4 Remove the film, and load an unexposed film.
● Pull the end of the film out to the FILM TIP mark
and correctly load the film.
● Be sure not to move the camera back lock while
film is loaded in the camera. When removing the
film, check that the motor has stopped and that
“
” is displayed before opening the camera back.
● After removing the film, remove the battery, press
the POWER button, and check that the exposure
counter is no longer displayed. Then insert the
battery again.
● Cancel the date correction mode.
● Please contact a FUJIFILM authorized distributor.
12
11
23
17
17
28
30
28
13
1 “
” symbol is blinking.
2 Power switch is not on.
3 Is “
” blinking on the LCD?
4 “
” is lit on the exposure counter.
● Did you pull the end of the film out to
the FILM TIP mark when loading the
film?
● Did you move the camera back lock
while a film was loaded?
● Did you remove film without rewinding
it after you began photographing?
● Is the date correction mode on?
● The camera is broken.
The shutter release won’t
trip.
After loading the film and
closing the camera back,
the exposure counter is
not displayed.
The film rewound during
photographing.
After loading a film and
closing the camera back,
the numerals on the expo-
sure counter blink.
The self-timer cannot be
set.
“ ” is blinking and the shut-
ter can not be released.
Problems Possible Causes Solutions Page