Filter
Top Products
Rugged Dome Installation Manual Preparing the Housing and Camera
1038346B / February 2003 5
1 PREPARING THE HOUSING AND CAMERA
Using the provided Allen wrench, loosen the tamper-resistant housing
cover screws.
• If your unit has the factory-installed flying lead with coaxial video
cable, proceed to section 2 to mount the unit.
• If your unit has the factory-installed UTP module, ensure that the
jumpers illustrated in Figure 2 are disconnected. Then proceed to
section 2 to mount the unit.
• To retrofit your unit with the UTP module, proceed to section 1.1.
See Figure 1 during the installation process.
Back conduit
entry
Side conduit
entry
Inner plate
mounting holes (3)
Flying
lead
PC assembly Camera UTP module
mounting post
Figure 1. Interior of housing