4
SkyView Linux-DVR installation steps
Step1:
At beginning, select “Installation” and key in “autoyast=file:///eng.xml”
below at “Boot Options” and press” Enter” for automatic installing Linux O.S and
configurations setup. (1st hard disk will automatically partition; 2nd hard disk above
need to partition manually; Please refer to CD user manual for more information)
After key in “autoyast=file:///eng.xml”, on the installation processing about 30 minutes,
there will be some installing screens appear. However, just not care them until the below
page show up, which means the O.S. installation is done.
Click “close” to shut the page.
Select: “Installation”
Key in “autoyast=file:///eng.xml”
Click “close”
Select “Boot from Hard Disk”