Filter
Top Products
Page 4SKU 91309 For technical questions, please call 1-800-444-3353.
Monitor and Underwater Camera Specific Safety Warnings
1. Keep the Monitor (2) out of the direct sunlight. Do not let it overheat, freeze, or be
exposed to wet conditions.
2. Do not locate the Monitor (2) near radiators, ovens, or any other heat source.
3. Always handle the Monitor (2) and the Camera (1) with care. Do not allow either to
experience shaking or strong vibration. Never use the Camera in surf, near a pier, rocks,
or any other obstacle.
4. To allow air circulation, locate the Monitor (2) at least two inches from walls, cabinets, or
other enclosures.
5. When connecting the Camera (1) to the Monitor (2), the power must be off or both
units will be damaged.
6. Do not tip or drop the Battery (4). Tipping or dropping will cause acid to leak. If
acid leaks on you, immediately wash off the acid with cold water. Seek medical
attention immediately.
7. Always keep the RED (+) terminal on the Battery (4) disconnected unless the system is
being used. When connected, it will constantly drain the Battery (4).
Operation
Connecting the system
Note: This is a 12 Volt DC system and will not work on 24 Volt DC systems; hooking
the monitor up to a 24V system can damage or ruin this product.
Rear Inputs shown in FIGURE 1:
DC 12 Volt In - Plug in 12 VDC power system here.
VCR Camera - When the switch is set on “VCR”, you can record footage to a VCR. When
the switch is on “Camera”, It will show the footage being captured by the Camera.
Video Out - to be used to record to a VCR.
Video In - Can be used as a video-only monitor (no sound).
C1 - Camera connection.
C2 - Second camera connection.
DC 12 Volt In
VCR Camera
Video In
C1
Video Out
C2
FIGURE 1
FIGURE 2
Battery
Cord (5)
Battery (4)
Camera (1)
Monitor (2)
65 Foot Cable (3)