Filter
Top Products
hp photosmart
140 series
1 unpack your printer
2 plug in the power cord
Place the printer at least 10 inches (250 mm)
away from any obstruction to allow space for the
paper to move through the printer during printing.
1. Connect the power cord to the back of your
printer.
2. Plug the power cord into a working electrical
outlet.
Important: Make sure the power cord does not
block the rear paper path.
3 load an index card
Note: The index card will be used to print a
calibration page in step 6.
1. Open the paper tray door.
2. Place an index card from the sample pack on
the paper tray and slide the card underneath
the output guide.
3. Move the paper width guide to fit close to the
left edge of the index card without bending
the card.
setup
guide
Q3025-90153
HP #57
Output guide
Paper width guide
Paper tray
Rear paper path
*Q3025-90153*