Filter
Top Products
8. Installation
BE-IR20 / 21
7
When installing the camera in a housing or unit of equipment, secure with two M2 screws
inserted into the 2.5 mm diameters holes of the SENS board base plate.
1. Use the SENS board holds to install the camera. Avoid using only the Main board,
due to risk of damage to the board connector.
2. Avoid unnecessary stress on the printed board when engaging and disengaging the
connectors.
3. The screws securing the base plate and SENS board protrude a maximum of 2 mm
from the base plate. Observe these screws do not contact the housing or installed
equipment.
Two 2.5 mm Dia.
SENS board
Notes :